-40%
BUTTON REPAIR PAD Tempur-Pedic Ergo 10003-RFREMS-L009 Remote Sealy
BUTTON REPAIR PAD Tempur-Pedic Ergo 10003-RFREMS-L009 Remote Sealy
BUTTON REPAIR PAD Tempur-Pedic Ergo 10003-RFREMS-L009 Remote Sealy
BUTTON REPAIR PAD Tempur-Pedic Ergo 10003-RFREMS-L009 Remote Sealy
BUTTON REPAIR PAD Tempur-Pedic Ergo 10003-RFREMS-L009 Remote Sealy

BUTTON REPAIR PAD Tempur-Pedic Ergo 10003-RFREMS-L009 Remote Sealy

$ 6.84

  • Brand: ButtonWorx
  • Compatible Mattress Size: does not apply
  • Department: Adults
  • Frame Material: Unknown
  • Item Height: Less than 12 in
  • Item Length: Less than 50 in
  • MPN: Does Not Apply
  • Model: Tempurpedic Ergo Premier
  • Original/Reproduction: Original
  • Room: Bedroom
  • Seller Notes: “** NOT A REMOTE ** Do-It-Yourself button repair membrane. Requires TORX T8 screwdriver to open”
  • Type: Buttons
  • UPC: Does not apply
  • gtin13: Does not apply

Description

** Requires TORX T8 screwdriver bit to open remote ** TEMPUR PEDIC TEMPUR-Ergo HSC-TP-RF-TAES 100003-RFREMS-L008 Remote Control Membrane Keypad Repair Pad Do-It-Yourself Permanent Repair PUT-IN-PLACE Easy Installation No paint ink or glue Will not chip or flake off Tested over 1 Million button presses! Blocks dirt and oils forever NOTE : Requires Torx T8 screwdriver to open remote Permanently repairs rubber keypad buttons by adding a new layer of conductive material. Your buttons fails when the conductive pad wears out and silicone oils seep from the keypad. This gooey paste blocks electrical conductivity and stops the switch from working. The ButtonWorx membrane keypad blocks dirt and oil from reaching the circuit board and offers a new conductor that cannot break down like rubber conductors do. Note: This is for repairing hard to press buttons. If all your buttons stopped working one day, then the remote is broken (not the buttons) and needs repair Our membrane keypads are custom cut for each model. IMPORTANT : CLEAN THE CIRCUIT BOARD WITH ISOPROPYL ALCOHOL Install the ButtonWorx™ repair membrane FLAT FLAT FLAT. There is no need to make sure it is stuck down. Do Not press down on the button areas. That can cause buttons to cave in creating a permanent short circuit. Just place it down using the holes for alignment. If it needs to be repositioned you can remove it and try again.